LED Lighting Controller with Ethernet ConnectivityOPPD-30 Series

DOWNLOAD

Easy Ethernet connectivity

  • Mitsubishi Electric iQSS support
  • Automatic brightness management
OPPD-30 Series

Specifications

Model OPPD-30E
Power supply voltage 24 VDC ±10%
Current consumption Max. 1.3 A
Illumination output 2 ch
Connectable lighting Max. 30 W (total for 2 channels)
Illumination output voltage PWM mode: 12 VDC
Illumination output current Max. 2.5 A (total for 2 channels)
Dimming method PWM dimming, Frequency: 50/100/99/98/97 kHz
Monitoring Lighting brightness monitor / Lighting internal temperature monitor,
Monitor brightness alarm upper/ lower limit value setting
Feedback PWM correction method
Input External illumination control × 2
ON voltage: 12 V or more, OFF voltage: 2 V or less, Max. input voltage: 30 V
Input response time (actual value)
With 24 V input (OFF→ON: 5 μs), (ON→OFF: 50 μs)
With 12 V input (OFF→ON: 8 μs), (ON→OFF: 45 μs)
Input resistance: 3.9 kΩ, insulated
Communication interface Ethernet 10BASE-T/100BASE-TX, AutoMDI-X
Communication protocol UDP/IP, DHCP, iQSS
Communication response speed From command reception to response completion: 6 ms (typ.)
Protective functions Overcurrent, power supply internal temperature monitoring
(PWM output cut to 1/4 at 105°C)
Applicable regulations EMC (2014/30/EU) / RoHS (2011/65/EU, directive 32)
Applicable standards EN 61326-1: 2013, EN 55011: 2009 / A1: 2010 Group 1, Class A
Protection rating IP30 (IEC 60529: 1989 / A1: 1999 + A2: 2013)
Ambient temperature/humidity 0 to 40°C / 35 to 85% RH (no condensation)
Storage temperature/humidity -20 to 70°C / 35 to 95% RH (no condensation)
Vibration resistance 10 to 55 Hz; amplitude: 1.5 mm; 2 hours in each of the X, Y, and Z directions
Shock resistance Approximately 10 G, 3 times in each of the X, Y, and Z directions
Insulation resistance 500 VDC, 10 MΩ or more
Material Housing: Polycarbonate and aluminum
Weight 150 g
Accessories Terminal block × 1
Options Panel mounting bracket, Panel stand

Required 24 VDC power supply capacity to handle power consumption of lighting

  • Based on the total power consumption of the LED lighting to be connected, select a 24 VDC power source that offers more than the required capacity

    Note:
    When using in conjunction with other equipment, the characteristics of the other equipment will affect the power supply, so be sure to choose a power supply that has a sufficient margin (about twice as much) as that shown in the table.