Circuit Diagram

NPN output type

*White lead wire: ② is only equipped to BGS-S08☐, -2S30☐T

PNP output type

Connector type

*Pin No. ② is not used for BGS-2S10☐, -2S15☐, -2S30☐.

Notes

• When using a switching regulator for the power supply, be sure to ground the frame ground terminal.
• Avoid wiring in parallel with or in the same piping as high-voltage wires or power lines. Doing so may lead to malfunctions caused by noise. Also, shorten the power supply and signal wires as much as possible.
• Avoid using the transient state while the power is on (approx. 100 ms).
• The connector direction is fixed as in the drawing to the right when you use L-shaped connector cable. Be aware that rotation is not possible.